Home Diet Adult Fitness Sports Fitness Senior Fitness Youth Fitness Prevention Stress Health Conditions Wellness Resources About Contact |
[ Golf Conditioning ] [ Strength Training for Rowing ] [ Strength Training for Tennis ] [ Strength Training for Rock Climbing ] Better Rowing Through Strength Training
Wayne L. Westcott, PH.D., CSCS
If you enjoy rowing, canoeing, or kayaking, then the information in this section should
be most helpful for improving your rowing/paddling performance and reducing your risk of
muscle overuse/imbalance injuries.
The first objective is to strengthen the muscles used in these activities for more
powerful rowing/paddling actions. To do this we will concentrate on those exercises that
specifically address the rowing muscles. However, the second objective is to strengthen
the muscles not used in these activities, especially the opposing muscle groups that must
balance the prime mover muscles and maintain joint integrity throughout thousands of
repetitive rowing movements. That is, you need a sound and sensible strength training
program for comprehensive musculoskeletal conditioning. This will become more obvious when
you realize how much musculature is actually involved in rowing/paddling activities.
Lets begin with a basic analysis of the rowing action as produced by the
contributing muscle groups, and the recommended resistance exercises for strength
conditioning. The first movement in sliding seat rowing is extension of the legs, starting
with the muscles that straighten the knees. These are the quadriceps muscles of the front
thighs, the largest and strongest muscles in the body. The second and almost simultaneous
movement is extension of the hip joint, which is accomplished by the opposing
hamstrings muscles of the rear thighs. The single best strength exercise for the
quadriceps muscles is the leg extension, and the single best exercise for the hamstrings
muscles is the leg curl (either seated or prone). The exercise that most effectively works
both the quadriceps and hamstrings muscles at the same time is the leg press. As shown in
Table 1, these three leg exercises should be performed first in the strength training
program, as they are responsible for the initial power production of every rowing action.
The next phase of the rowing action is extension of the trunk, which is produced by
contraction of the lower back muscles. Although the erector spinae muscles can become
extremely strong, the lower back represents a most vulnerable area of the body for many
people. You must therefore train these important muscles in a careful and progressive
manner to reduce the risk of injury during the strengthening process. Without question,
the best exercise for safely developing stronger lower back muscles is the low back
machine. However, to ensure comprehensive midsection conditioning you should combine the
low back exercise with the abdominal machine and the rotary torso machine. These three
exercises address the erector spinae muscles of the rear midsection, the rectus abdominis
muscles of the front midsection, and the oblique muscles (internal and external) on both
sides of the midsection, respectively. All of these midsection muscles are involved in
efficient force transfer from the lower body to the upper body, and should be included in
each strength training session. Due to their stabilization function in essentially every
strength exercise, I recommend placing the midsection exercises at the end of each workout
(see Table 1).
The next aspect of the rowing sequence is the arm pulling action that actually moves
the oars through the water to propel the boat forward. Although always challenging, the
arm pull is much easier when it is appropriately timed to immediately follow the trunk
extension movement. The prime mover muscles for the arm pull are the latissimus dorsi and
teres major muscles of the upper back, the rear deltoid muscles of the shoulders, and the
biceps muscles of the arms, with assistance from the large shoulder retractor muscles
(upper trapezius, middle trapezius, and rhomboids). The super pullover machine is most
productive for isolating the latissimus dorsi and teres major muscles, and should be
followed by the compound row machine that addresses these muscles, the posterior deltoid
muscles and the biceps muscles, as well as the upper trapezius, middle trapezius, and
rhomboids. Additional biceps conditioning can be obtained by using the biceps machine.
These exercises should be performed in the order presented in Table 1. To ensure muscle
balance and joint integrity in the upper body you should also do exercises for the
opposing muscle groups, namely the pectoralis major, anterior and middle deltoids and
triceps. As shown in Table 1, the chest press, shoulder press and triceps extension
exercises achieve this purpose and should be included in your strength training program
where indicated.
All of the strength exercises should be performed 2 of 3 days per week, typically in a
total body workout that can be completed in less than 30 minutes. One properly performed
set of each exercise should be sufficient, with approximately one minute recovery time
between successive exercises. Proper exercise performance is characterized by full
movement range and slow movement speed on every repetition. I suggest taking about 6
seconds for each repetition, with 2 seconds for the more challenging lifting movement and
4 seconds for the otherwise less challenging lowering movement. Use enough resistance to
fatigue the target muscles within the anaerobic energy system, generally during a range of
50 to 70 seconds. At 6 seconds per repetition, this corresponds to about 8 to 12 good
repetitions per exercise set. Whenever you can complete 12 repetitions in proper form, you
should increase the weightload by approximately 5 percent (or less). For most exercises,
this requires adding 2 to 10 pounds, which will of course reduce the number of repetitions
that you can perform, accordingly. Train with the higher resistance until you can again
complete 12 repetitions, then add an appropriate amount of weight to your next workout.
Keep careful records of all your training sessions for purposes of progression and
motivation.
Table 1. Recommended strength exercises and training order for increased
rowing/paddling power.
Exercise Relevance
Muscle Group
Rowing
| Leg
extension |
Quadriceps |
Power production |
| Leg curl |
Hamstrings |
Power production |
| Leg press |
Quadriceps, hamstrings,
gluteals |
Power production |
| Super
pullover |
Latissimus dorsi, teres
major |
Arm pull |
| Compound row |
Latissimus dorsi, teres
major, biceps, upper
trapezius, middle trapezius,
rhomboids |
Arm pull |
| Biceps curl |
Biceps |
|
| Chest
press |
Pectoralis major, anterior
deltoids, triceps |
Joint integrity |
| Shoulder press |
Anterior deltoids, middle
deltoids, triceps |
Joint integrity |
| Triceps
extension |
Triceps |
Joint integrity |
| Low
back |
Erector spinae |
Force transfer |
| Abdominal |
Rectus
abdominis |
Force transfer |
| Rotary
torso |
Internal obliques, external
obliques |
Force transfer |
Wayne L. Westcott, Ph.D., C.S.C.S, is
Fitness Research Director at the South Shore YMCA in Quincy, MA. He is strength training
consultant for numerous national organizations, such as the American Council on Exercise,
the American Senior Fitness Association, and the National Youth Sports Safety Foundation,
and editorial advisor for many publications, including Prevention, Shape, and Club
Industry magazines.
He is also author of 20 fitness books
including the new releases, No More Cellulite, Building Strength and Stamina, Strength
Training Past 50, Strength Training for Seniors, Complete Conditioning for Golf, and
Strength and Power for Young Athletes.
[ Back ] [ Next ]
[ Home ] [ Diet ] [ Adult Fitness ] [ Sports Fitness ] [ Senior Fitness ] [ Youth Fitness ] [ Prevention ] [ Stress ] [ Health Conditions ] [ Wellness Resources ] [ About ] [ Contact ] |
|